EFFECT OF BINDER COMPOSITION AND SINTERING TEMPERATURE ON THE MICROSTRUCTURE AND MECHANICAL PROPERTIES OF WC-7(Ni,Fe) HARD ALLOYS

Authors

  • Phuong Dinh Doan Institute of Materials Science, Vietnam Academy of Science and Technology
  • Trung Bao Tran Institute of Materials Science, Vietnam Academy of Science and Technology
  • Chung Danh Le Institute of Materials Science, Vietnam Academy of Science and Technology
  • Hung Ba Tran Center for High Technology Development, Vietnam Academy of Science and Technology

DOI:

https://doi.org/10.12776/ams.v25i2.1270

Keywords:

hard alloys, hot isostatic pressing, Vickers hardness, fracture toughness

Abstract

In this research, WC-7(Ni,Fe) hard alloys were prepared by ball milling, cold compaction and finally consolidated by hot isostatic pressing. The effect of binder composition and sintering temperature were investigated in term of the microstructure, density and mechanical properties of sintered samples. Density of hard alloys was measured by the Archimedes' principle while the microstructure was observed using a scanning electron microscope. The Vickers hardness was investigated at load of 30KG and the fracture toughness was calculated based on the Palmqvist crack method. The results revealed that the density of sintered samples was obtained in the range of 14.65 to 14.8 g/cm3 meanwhile the measured Vicker hardness and fracture toughness were respectively achieved from 1260 to 1520 HV30 and 11,7 to 17,5 MPa.m1/2 depending on the binder composition and sintered temperature.

Downloads

Published

2019-06-28

How to Cite

Doan, P. D., Tran, T. B., Le, C. D., & Tran, H. B. (2019). EFFECT OF BINDER COMPOSITION AND SINTERING TEMPERATURE ON THE MICROSTRUCTURE AND MECHANICAL PROPERTIES OF WC-7(Ni,Fe) HARD ALLOYS. Acta Metallurgica Slovaca, 25(2), 123–129. https://doi.org/10.12776/ams.v25i2.1270