Vol. 26 No. 3 (2020): Volume 26, No.3, 2020

Published: 2020-09-10

Research papers

Friction welding of AISI 304: effect of friction time on micro-structure, micro-hardness and tension-compression properties

Ammar JABBAR HASSAN, Taoufik BOUKHAROUBA, Djamel MIROUD

78-83
- pdf
EVALUATION OF THE INFLUENCE OF WASTE GLASS POWDER (WGP) ON THE THERMO-MECHANICAL PERFORMANCE OF FIRED CERAMICS

Adeolu Adediran, Abayomi Akinwande, Oluwatosin Balogun, Oladele Bello, Abel Barnabas, Peter Balogun, Olanrewaju Adesina

84-94
- pdf
THE EFFECT OF COLD DEFORMATION AND ANNEALING PHENOMENA ON THE MICROSTRUCTURAL CHANGES AND MICRO-HARDNESS IN Al-Mg-Si ALUMINIUM ALLOYS

Abdelouahab NOUA, Meryem GUEMINI , Toufik ZIAR, Hichem FARH, Rebai GUEMINI

95-99
- pdf
Facile Decoration of Silver Nanowires Microstructure with Carbon Nitride Nanoparticles as a Membrane for Water Treatment

Thuyet Minh Nguyen, Hung Thai Le, Khanh Quoc Dang

100-103
- pdf
PROGRESSIVE CMT CLADDING FOR RENOVATION OF CASTING MOLD

Janette Brezinova, Miroslav Džupon, Jan Vinas, Anna Guzanová, Viktor Puchý, Jakub Brezina, Dagmar Draganovská, Marek Vojtko

104-110
- pdf
HEAT TREATMENT EFFECT ON INTERFACE MICROSTRUCTURE AND HARDNESS OF A MEDIUM CARBON STEEL CLADDED BY AISI 316 STAINLESS STEEL

Andrea Di Schino

111-115
- pdf
Element partitioning in low-carbon Si2Mn2CrMoVNb TRIP-assisted steel in intercritical temperature range

Vasily Efremenko, Roman Kussa, Ivan PETRYSHYNETS, Kazumichi SHIMIZU, František KROMKA, Vadym ZURNADZHY, Victoria GAVRILOVA

116-121
- pdf
UTILIZATION OF ANALYTICAL METHODS FOR THE FAILURE ANALYSIS OF INJECTION MOLDED PART

Ivan Gajdoš, Ján Slota, Ľuboš Kaščák, Oleksandr Grytsenko, Tomasz Jachowicz

122-125
- pdf
CORROSION AND WEAR PERFORMANCE OF ZA27/GRAPHENE/B4C HYBRID NANOCOMPOSITES PRODUCED BY POWDER METALLURGY

Emre Deniz YALÇIN, Aykut ÇANAKÇI

126-131
- pdf
Oblique Gate Direction During Centrifugal Casting in Artificial Lumbar Disc Model of CP-Ti

Lilik Dwi Setyana, Muslim Mahardika, suyitno suyitno

132-137
- pdf