MANUFACTURABILITY VERIFICATION AND COMPARISON OF QUALITY PARAMETERS OF SHAPED SURFACE

Authors

  • Miroslav Tomáš
  • Dagmar Draganovska
  • Juraj Hudák
  • Peter Ižol

DOI:

https://doi.org/10.12776/ams.v20i1.274

Keywords:

tool steel, stamping, simulation

Abstract

The paper describes stamping punch production from the view manufacturability and quality of stamping punch active surfaces. The tin car-body stamping punch has been chosen as a subject of experimental work. The experimental stamping punch has been made out of Textit and production stamping punch has been made out of tool steel X210Cr12. Milling strategies has been proposed and verified using CAM software SolidCAM considering the maximum Scallop Height. The roughness parameters Ra and Rz measured on selected areas of stamping punch shaped surface were compared to Scallop Height. Manufactured areas on shaped surface were optically evaluated as well. The application of proposed procedure is shown as an example of manufacturability for experimental and production stamping punch designed for complex parts production.

Downloads

Published

2014-03-31

How to Cite

Tomáš, M. ., Draganovska, D. ., Hudák, J. ., & Ižol, P. . (2014). MANUFACTURABILITY VERIFICATION AND COMPARISON OF QUALITY PARAMETERS OF SHAPED SURFACE. Acta Metallurgica Slovaca, 20(1), 105–114. https://doi.org/10.12776/ams.v20i1.274

Issue

Vol. 20 No. 1 (2014): Volume 20, no. 1, 2014

Section

Research papers

Most read articles by the same author(s)