Imprinted polymers in analytical chemistry

Authors

  • Jozef Lehotay Institute of Analytical Chemistry, Faculty of Chemical and Food Technology, Slovak University of Technology, Radlinského 9, Bratislava, SK-812 37, Slovak Republic
  • Miroslava Lachová Institute of Analytical Chemistry, Faculty of Chemical and Food Technology, Slovak University of Technology, Radlinského 9, Bratislava, SK-812 37, Slovak Republic
  • Ján Mocák Department of Chemistry, University of SS. Cyril and Methodius, J. Herdu 2, Trnava, SK-917 01, Slovak Republic

DOI:

https://doi.org/10.36547/nbc.1144

Keywords:

HPLC, molecularly imprinted polymer, SPE

Abstract

Molecularly imprinted polymers were prepared and tested in different way. 1-methyl-2-piperidinoethylester of 4-decyloxyphenylcarbamic acid was used as template for imprints formation. Acrylamide, 4-vinylpyridine and methacrylic acid as monomers and methanol and acetonitrile as a porogene were used. Non-imprinted polymers (NIP) were prepared for each imprinted polymer by the same procedure. Polymers were employed as sorbents for solid-phase extraction (SPE). In this work the influence of polymerization mixture composition on polymer properties, such as capacity and selectivity, was investigated. The influence of alkoxy-chain length and position on benzene ring on the selectivity of polymers was also investigated.

Downloads

Published

2021-09-02

How to Cite

Lehotay, J., Lachová, M., & Mocák, J. (2021). Imprinted polymers in analytical chemistry. Nova Biotechnologica Et Chimica, 9(3), 341-347. https://doi.org/10.36547/nbc.1144

Issue

Section

Research Articles
Received 2021-09-02
Published 2021-09-02